[Mageia-dev] drakxtools & drakx-installer-stage2 (mga#9428)

[Glen Ogilvie]

On 23 March 2013 05:12, AL13N <alien at rmail.be> wrote:

> Op vrijdag 22 maart 2013 07:38:56 schreef Frank Griffin:
> > On 03/22/2013 07:20 AM, Glen Ogilvie wrote:
> [...]
> > > 1. How does the src tar.xz file for drakx-installer-stage2 get
> > > created?   I assume it comes from a
> > > build of svn://svn.mageia.org/svn/soft/drakx/trunk
> > > <http://svn.mageia.org/svn/soft/drakx/trunk>, but can't find how it
> > > ends up as a tar.xz
> >
> > I'm maybe about two days ahead of you on this, but here's what I think
> > happens, FWIW.  You do your checkout, and then in the mdk-stage1
> > subdirectory, do a "make dist-svn".  This should produce the tar.xz in
> > the mdk-stage1 directory.
> [...]
>
> "make dist" actually...
>
> it will target make "dist-svn" or "make dist-git" depending on if you're
> using
> git-svn or not.
>
> be advised that dist-svn uses the BASE and any uncommitted change will not
> be
> applied.
>
> dist-git however, you can commit without pushing them and that will be
> used.
>
>
I've had a good play around with make dist.
It seems to me, like running make dist in the perl-install directory,
(svn://svn.mageia.org/svn/soft/drakx/trunk/ )
does not produce the same tar.xz file as found within
drakx-installer-stage2 sources.
For example, the tar.gz produced by "make dist" does not contain the
"kernel", "perl-install/install" directories, etc.
Also, inside the tar, the first directory is: "drakxtools-15.29", rather
than "drakx-installer-stage2-15.29".  It is also
only 2.4MB instead of about 4.3MB.

Any suggestions?

Regards
Glen
-------------- next part --------------
An HTML attachment was scrubbed...
URL: </pipermail/mageia-dev/attachments/20130323/24a54bf4/attachment.html>