[Mageia-discuss] Gimp , Gwenview printing

[Florian Hubold]

Am 22.09.2011 23:01, schrieb Gary Montalbine:
> At the end of September I mentioned that gwenview print ass't did not print 
> the photos with the proper color. I have included the gimp photo. This was 
> used in both ML and Mageia. The ML printed image and the Mageia printed image 
> are also included. I used print ass't in both. The mageia image shows poor 
> color. There is too much red.
>
> I had to reinstall ML2010.2 to print good quality photos via gwenview and 
> print ass't..
>
> I just did a retest since hplip was updated. I did a minimal install on a 
> flash drive and then an update of all installed software. Around 500 updates. 
> I then reprinted the gimppic using print ass't in Gwenview and gutenberg 
> print in gimp. They both produced the same unsatisfactory photos as before 
> and shown as mmageia.jpg.
>
> It appears I may be the only one with this problem. I wonder if it might be 
> the hplip drivers. I am using a HP Photosmart Plus 209a-m. I think I remember 
> seeing 209a-c listed in Mageia.
>
> I am forced to remain with ML2010.2 because of the printing issue.
>
> Thanks, Gary
>
Already asked you that in private, IIRC, but have you tried with other programs?