[Mageia-dev] drakxtools & drakx-installer-stage2 (mga#9428)

[Pascal Terjan]

On 22 Mar 2013 22:21, "Glen Ogilvie" <nelg at linuxsolutions.co.nz> wrote:
>
> On 23 March 2013 05:12, AL13N <alien at rmail.be> wrote:
>>
>> Op vrijdag 22 maart 2013 07:38:56 schreef Frank Griffin:
>> > On 03/22/2013 07:20 AM, Glen Ogilvie wrote:
>> [...]
>> > > 1. How does the src tar.xz file for drakx-installer-stage2 get
>> > > created?   I assume it comes from a
>> > > build of svn://svn.mageia.org/svn/soft/drakx/trunk
>> > > <http://svn.mageia.org/svn/soft/drakx/trunk>, but can't find how it
>> > > ends up as a tar.xz
>> >
>> > I'm maybe about two days ahead of you on this, but here's what I think
>> > happens, FWIW.  You do your checkout, and then in the mdk-stage1
>> > subdirectory, do a "make dist-svn".  This should produce the tar.xz in
>> > the mdk-stage1 directory.
>> [...]
>>
>> "make dist" actually...
>>
>> it will target make "dist-svn" or "make dist-git" depending on if you're
using
>> git-svn or not.
>>
>> be advised that dist-svn uses the BASE and any uncommitted change will
not be
>> applied.
>>
>> dist-git however, you can commit without pushing them and that will be
used.
>>
>
> I've had a good play around with make dist.
> It seems to me, like running make dist in the perl-install directory,
(svn://svn.mageia.org/svn/soft/drakx/trunk/ )
> does not produce the same tar.xz file as found within
drakx-installer-stage2 sources.
> For example, the tar.gz produced by "make dist" does not contain the
"kernel", "perl-install/install" directories, etc.
> Also, inside the tar, the first directory is: "drakxtools-15.29", rather
than "drakx-installer-stage2-15.29".  It is also
> only 2.4MB instead of about 4.3MB.
>
> Any suggestions?

Yes, you need to go into install subdirectory (if I remember the name
correctly)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: </pipermail/mageia-dev/attachments/20130322/9d51da93/attachment.html>